1/7/2024 0 Comments 90 degree scaffold couplerWhat should be considered and what are the technical details of the scaffold coupler?Īll couplings are produced according to EN 74 and are provided with the corresponding test mark. Use as kwikstage system parts, the band and plate coupler is no need a hole on. You can use band and plate for South Africa kwikstage scaffolding system. This should include: type of scaffold (tube and fitting or system) maximum bay lengths. It enables scaffold boards and battens onto the top of the scaffold tube. Putlog couplers Wrap around two vertical scaffolding tubes without leaving a gap. It Enables Scaffold Guardrail and Midrails to Standard Scaffold Tube at 90 Degree. Prior to installation, the scaffold contractor or scaffold designer can then provide relevant information about the scaffold. Our Putlog Coupler Connects Scaffold Tubes and Transom in O.D 48.3mm. En74 BS1139 90 Degree Forged Scaffolding Clamp Specification Capacity Types Scaffolding Gi Pipe Tube Swivel Coupler Clamps Price. The band and plate coupler is used to fixed your 48.3mm scaffold tube in right angle 90 degrees. any restrictions that may affect the erection, alteration or dismantling process. Sill (sole boards) was missing /Remove and install sill (sole boards) Base lift was more than six inches. Wellmade is Band and Plate Scaffold Manufacturer in China. 119 The post spacing depends in tube and coupler scaffold on H e i g h t L e n g t h W i d t h Load rating B. The material of the hammerhead bolt and collar nut is steel yellow zinc plated. 10 -20 degree 75-90 degree 35-55 degree 60-75 degree C. In manufacturing, DH couplers are with an M20 bolt and a B-shaped body. Gravlock couplers are used to attach 48mm scaffold tube to a girder / steel beam at 90 degrees. It is used to attach scaffold tubes to the scaffolding standards at a right angle (90 degrees). The hammerhead bolt has a metric thread and the collar nut has a wrench size of 22. For fixing scaffold tubes at 90 degrees, for example a vertical and horizontal tube. In construction, the putlog coupler joints scaffold putlogs or transoms onto scaffold ledgers at 90 degrees (right angle). Our Rigid Coupler is made of hot-dip galvanized steel and ribbed design. How is the clamp constructed and how is it used?The scaffold clamps have a diameter of 48 and 60 mm and are used to connect scaffold tubes with a diameter of 4.83 cm and 6.00 cm. They are used as a rigid connection of scaffold tubes or also in connection with our scaffold anchors to fix the scaffold to the wall. Our standard couplers connect two scaffold tubes with different diameters at 90° to each other.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |